EA is a 2K reaction resin mortar based on epoxyacrylate and will be delivered in a 2-C cartridge (ST – standard cartridge; PM – Pre-Mix cartridge; SF-foil tube cartridge) system. This product may be used in combination of a hand-, battery-, or pneumatic tool and a static mixer. It was designed as a cost-effective alternative for the anchoring of threaded rods and internal threaded rod sleeves for approved applications. By using a screen sleeve, an easy and save application in hollow bricks is guaranteed. The EA product is characterised by good applications with an ambiance temperature up to 80°C.
- Cartridge can be reused up to the end of the shelf life by replacing the static mixer or resealing cartridge with the screw cap
- Application in uncracked concrete, solid brick and hollow brick with comercial threaded rods
- Suitable for attachment points close to the edge, since anchoring is free of expansion forces
- Mechanical properties acc. to EN 196 Part1 + Density: 1,66 kg/dm
- High bending - and pressure strength
- European approval in concrete
- Reduced chemical resistance
- Overhead application
Particulary for heavy duty fastening using threaded studs and reincforcing bars in concrete. Aloso for use in damp and water filled drill holes.
non-cracked concrete, light-concrete, porous-concrete, solid masonry, hollow brick, natural stone (Attention! natural stone, can discolour; shall be checked in advance); hammer drilled holes
Threaded rods (zinc plated or hot dip, stainless steel and high corrosion resistance steel), reinforcing bars, internal threaded rods, profiled rod, steel section with undercuts (e.g. perforated section)
5°C up to +35°C installation temperature cartridge temperature min. +5°C; optimal +20°C
-40°C to +80°C base material temperature after full curing
-40°C to +80°C base material temperature after full curing